Milltronics PL-551 Technické informace stáhnout pdf (Strana 115)

100

101

SECTION TWO - FRONT PANEL OPERATION

F5 (Send) Main-Util-RS232-Send

When F5 (Send) is depressed, the following keys appear.

After selecting F1 (Text) or F2 (Conv), select which programs you want to send to the off-line

computer from the menu. These actions will display the following menu.

F1 (Begin) starts transmission of the active send program that is shown in the upper right-hand

corner.

F7 (Menu) allows selection of programs from a menu to send.

Notes on Send

Note 1: If sending parameters, F7(Menu) is not an option.

Note 2: The RS-232 parameters must be set to the same values on both the control and the

computer. Always check these parameter settings.

Note 3: The RS-232 parameters are found in the control parameters (Main-Parms-Ctrl).

Normal parameter settings are:

Primary Port COM1

Baud rate 1200 through 9600

Parity Even

Data bits 7

Stop bits 2

F6 (Recev) Main-Util-RS232-Recev

The F6 (Recev) option is used to receive programs or parameters from an off-line computer into

the control program memory. Upon pressing the F6 (Recev) key, a new set of selection keys will

appear as shown below. Then a new program number must be entered in the message window.

Once a valid program number has been entered, the edit screen will appear and display the

program as it is received. Receiving will continue until the ESC (Done) key is pressed.

101

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 440 441

Milltronics PL-551 Technické informace Strana 115

Komentáře k této Příručce

Milltronics PL-551 Technické informace Strana 115

Komentáře k této Příručce

Související produkty a manuály pro ne Milltronics PL-551