Milltronics PL-551 Technické informace stáhnout pdf (Strana 157)

100

101

SECTION THREE - CONVERSATIONAL INPUT SCREENS

Mill START and END are not to be used with pocket routines.

Note: All milling auto routines must be activated with the tool at the center of the routine.

The conversational screen for pocket mill setup appears as follows.

Note: See pages 218, 225 in Section 4 and 316 in Section 5 for further information on pocket

routines.

F2 (Circ) Mill-Pockt-Circ

The F2 (Circ) selection brings up the following soft key selections.

F1 (Clear) Mill-Pockt-Circ-Clear

The conversational screen for CW circular pocket clear appears as follows.

Note: See page 218, Section 4 for further information on circular pocket clear.

143

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 440 441

Komentáře k této Příručce

Žádné komentáře

Milltronics PL-551 Technické informace Strana 157

Komentáře k této Příručce

Související produkty a manuály pro ne Milltronics PL-551