Milltronics PL-551 Technické informace stáhnout pdf (Strana 429)

100

101

APPENDIX

550 Bad numeric format

Always use square brackets in pairs.

554 Tangent function overflow

Expecting a numeric value, or a parameter value enclosed within [ ], after an

address X, Y, Z, R, etc.

551 Multiple decimal points

Multiple decimal points were detected within one numeric value.

552 Missing "]"

553 Missing "["

Always use square brackets in pairs.

Trying to find the tangent of a number close to 90Ε

555 Missing "/"

Arctan "ATAN" syntax is P## = ATAN[#/#].

556 Negative SQRT argument

557 Unknown function

560 Illegal relational operator

567 Unresolved call

Program being called does not exist (Call ####).

568 Unresolved goto or gosub

N#### does not exist in the program (Goto ####).

569 The tool is too large to cut inside the arc "Compensated radius is too small"

Eliminate the arc, or use a smaller tool.

570 The tool is too large to cut inside the arc "1st compensated radius in arc to arc

is < 0"

Eliminate the arc, or use a smaller tool.

571 The tool is too large to cut inside the arc "2nd compensated radius in arc to arc

is < 0"

Eliminate the arc, or use a smaller tool.

572 Pocket clear is not in a Start/End mill cycle

-WHILE WEND loop-

Use START at the beginning of the mill cycle and END at the end of the mill

cycle.

415

1 2 ... 424 425 426 427 428 429 430 431 432 433 434 ... 440 441

Milltronics PL-551 Technické informace Strana 429

Komentáře k této Příručce

Milltronics PL-551 Technické informace Strana 429

Komentáře k této Příručce

Související produkty a manuály pro ne Milltronics PL-551